Off topic from the original post.
Related only to the following issue reported later in this thread:
There is an issue with 64bit (possible only if fpc 3.0.4 is used, not sure) where step over, will step in.
This also is in latest trunk. Very aanoying
Try the following.
You need an "objcopy" for win 64 bit apps. The only one I could find is in the fpc-build repository, with the tools for cross compiling to 64 bits (but it works fine).
The one that comes with fpc 32 bit, will not work.
\FPC\SVN-build\install\crossbinw64\x86_64-win64-objcopy.exe -R .debug_frame project1.exe project1n.exe
If you do it right, it shrinks by just a few MB (an empty form1 goes from 27MB to 26MB)
then copy project1n.exe back to the original, or set "run parameters" to use the new one.
It may be possible to add this to project opitons "compiler commands"